This is the plug that for the hole that will be left behind once you remove the factory interior door handle when doing the door pull strap mod.
These are the 3D printed parts for a DIY door pull strap for your NC MX-5 Miata. This is a fun and easy DIY mod to give a little bit of a Porsche GT vibe. It also makes getting to the cup holder a little easier. Not only that, gives a little more room for your knee.
I don't believe these will work on an NC1. I don't have one to test with so keep that in mind before ordering.
This is ONLY the printed parts. The strap and hardware shown in the completed install are for reference only and not included.
The hole in the pull strap spacer and beauty washer are meant for an M6 screw. The spacer is a tight fit but will press in with little effort.
The armrest plug is an add on and it is a tight snap in installation into the hole.
These are made to order so please allow 2-3 business days for processing.
They are printed in black ABS.
To complete your door pull strap you will need 1 inch wide webbing of your favorite color and 2 M6x20 screws. If you go with fine thread you will have to use a little bit of force to get the fine threads of the machine screw to start to bight. But once they do everything will center itself up nicely.
The hardware I used in mine, the one shown in the example, are T27 M6x20 burnt titanium and red webbing.
